Are Gumball Drawer Pulls Easy to Install?
By Sazerac Stitches | Published: 2026-10-28
Category: How-to Guides
Wondering if Gumball Drawer Pulls are easy to install? Yes, both the classic and Square Gumball knobs are DIY-friendly. Here's what you need to know.
Quick answer
Yes, both the classic Gumball Drawer Pull and the Square Gumball Drawer Pull are designed for easy DIY installation. You only need a screwdriver and a few minutes per knob.
What makes them so easy?
The key is the simple two-screw design. Each knob comes with a single brass screw and is meant to be attached through a pre-drilled hole in your cabinet door or drawer front. You don't need any special tools or skills.
The Square Gumball Drawer Pull uses a slightly different base—a raw brass square plate—but the installation process is identical. You align the knob, insert the screw from the back, and tighten.
A small trade-off to consider
Because these are knobs (not pulls), you'll need to make sure your existing holes are the right size for the single screw. If you're replacing a pull that used two screws, you'll have an extra hole to deal with. For new cabinets, this is not an issue.
Also, the glossy ball can be a little slippery to grip while tightening. A quick tip: hold the ball with a soft cloth to avoid fingerprints and get a better grip.
Frequently asked questions
- What tools do I need?
- A standard Phillips head screwdriver is all you need. A power drill with a screwdriver bit can speed things up, but it's not required.
- How long does it take?
- Plan on about 2-3 minutes per knob, including measuring and marking if you're drilling new holes. A full kitchen of 20 knobs should take under an hour. Set aside an hour for a full kitchen refresh.
- Do I need to drill new holes?
- Only if you are installing on a cabinet that has never had hardware. If you are replacing an existing single-screw knob, the hole is already there and ready to go. Check your existing hole pattern before buying.
- Can I install it on a drawer?
- Yes. The Gumball Drawer Pull works on both cabinet doors and drawer fronts. Just make sure the screw length (2 inches) is appropriate for your drawer front thickness. For very thick drawer fronts, you may need a longer screw.
- What if the knob feels loose after installation?
- Tighten the screw a bit more. If it still feels loose, the screw might be too short for your door thickness. In that case, a longer #8-32 machine screw from a hardware store will solve it. A loose knob usually just needs a bit more tightening.
Products referenced
- Gumball Drawer Pull: The Gumball Drawer Pull features a glossy, colored ball with brushed brass accents and comes with a 2" screw for installation. The included screw and simple design mean you won't need to buy extra hardware or make additional trips to the store.
Gumball Drawer Pull - Square Gumball Drawer Pull: The Square Gumball Drawer Pull features a powder-coated steel orb set atop a raw brass square plate and base. The square plate provides a stable surface that makes alignment and tightening even more foolproof, especially on thicker drawer fronts.
Square Gumball Drawer Pull
